![]() We recommend using our passivation solution to prevent any surface corrosion from happening more information is available on our Engineering Specifications Page. NOTE: A small amount of surface corrosion is not uncommon after exposure to weather or salty conditions. To polish the cut, follow instructions for maintaining stainless steel surface.Be careful not to scratch the tubing while deburring keep the deburr tool straight Note: if necessary, ream/deburr the outside and inside of the tube.You’ll need to know the length of the pipe so that you can cut it to the correct size. Clean the tube using a paper towel and some household cleaner Step 1: Measure the Pipe The first step is to measure the pipe.File any sharp edges evenly with a fine metal file.Immerse the cut end into water to cool the cut tube In this video, well show you how easy it is to cut Tracpipe CSST (Corrugated Stainless Steel Tubing) and how to prep the tubing ready for fittings.Mark cutting point, clamp the tubing in place, and commence the cut.Place duct tape on the clamp of the cut-off saw and to all other areas where the tube will touch the metal to protect the surface from getting scratched while being cut.For round tubing, use 65S Stainless Steel Pipe Cutters.įor demonstration purposes, Inline Design is providing directions based on the use of the cut-off saw.Ĭaution: Wear protective ANSI-approved safety glasses, work gloves, and masks all the time. These saws will leave minimal burr and no heat marks. ![]() Inline Design recommends using a cold saw, band saw, preferably oil-fed. These directions will assist the user in properly cutting stainless steel tubes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |